TM 9-2320-269-20-1
AIRBRAKE CHAMBERS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
FRONT AXLE AIRBRAKE CHAMBER INSTALLATION - CONTINUED
33. Bracket (7)
Brake chamber (5)
Put on, and hold in place.
Be sure clevis fits over slack
adjuster.
34. Two studs (8)
Two flat washers (9)
Screw on, and tighten using 11/16-inch
and nuts (10)
socket and handle.
35. Clevis (11) and
Pin (13) and new
a. Using hammer, put pin (13) in place.
slack adjuster (12)
cotter pin (14)
b. Put pin (14) in place, and using
diagonal cutting pliers, separate ends
and bend back.
36. Coupling (6)
Hose (15) and hose-
Screw on, and tighten using 718-inch and
nut (16)
1-inch open-end wrenches.
37. Hose (15) and
New cable tie (18)
Put on, and pull tight.
harness (17)
NOTE
If right side brake chamber is being replaced, repeat steps 32 thru 37.
TA228890
2-501
Previous Page
