TM 9-2320-269-20-1
TRANSMISSION SHAFT AND CENTER BEARING - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
NOTE
If the center bearing and propeller shaft were not separated, go to step 13.
Before replacing yoke, check markings from removal to insure proper alinement.
9.
Yoke (11) and
Two dust covers (12)
Clean yoke (11) and shaft (3) of dirt or
corrosion using clean rags, and slide
shaft (3)
new covers (12) on.
10.
Propeller
Center bearing (7)
a. Wipe mounting surface (13) clean of
shaft (3)
dirt or old grease, and coat with
new grease.
b. Put on center bearing (7).
11.
Yoke (11)
a. Wipe shaft and yoke splines (14) clean
of dirt or old grease, and coat with
new grease.
b. Put on yoke (11).
12.
Shaft end (8)
Nut (9) and new
a. Put on shaft end (8) using 2 1/8-inch
cotter pin (10)
socket and ratchet handle with 1/2-
inch drive.
b. Tighten using 21/8-inch socket and
hinged handle with 1/2-inch drive.
c. Put in new cotter pin (10), and bend
into place using diagonal cutting
pilers.
2-467
Previous Page
