TRANSMISSION SHAFT AND CENTER BEARING - CONTINUED
INSTALLATION - CONTINUED
Put shaft (3) on hydraulic jack with wood
block, and lift into place.
Two screws (4),
a. Put in screws (4) with two flat
four flat washers
(5), and two
b. Screw on nuts (6) with two flat
washers (5), and tighten using
with 3/8-inch drive, and 5/8-inch
1. Install transmission propeller shaft yokes with mating yokes (page 2-457).
2. Lubricate center bearing (LO 9-2320-269-12).
TASK ENDS HERE