TM 9-2320-269-20-1
TRANSMISSION SHAFT AND CENTER BEARING
This task covers:
INITIAL SETUP:
Tools
Materials/Parts
Block, wood, 2-inch x 4-inch x 4-inch
Covers, dust
Caps, jaw, vise
Pin, cotter, shaft end nut
Hammer, ball-peen, 2-lb
Grease, GAA (item 17, appendix C)
Handle, hinged, 1/2-inch drive
Rags, wiping (item 24, appendix C)
Personnel Required
Jack, hand, hydraulic, 12-ton
Pliers, diagonal cutting
One
Puller, bearing
Punch, drive-pin, straight, 3/4-inch
Equipment Condition
Socket, 3/8-inch drive, 11/16-inch
Socket, 112-inch drive, 2 1/8-inch
Vise, machinist's
Wrench, open-end, 5/8-inch
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Be careful when removing propeller shafts. They are heavy, and if dropped can cause injury to personnel.
2-465