TM 9-2320-269-20-1
TRANSMISSION OIL COOLER LINES - CONTINUED
INSTALLATION - CONTINUED
NOTE
FOLLOW-ON MAINTENANCE:
1.
Service transmission (LO 9-2320-269-12).
2.
Start engine, operate transmission (TM 9-2320-269-10), and check for leaks.
TASK ENDS HERE
Section XIII. PROPELLER SHAFTS AND UNIVERSAL JOINTS
Page
Page
Propeller Shafts and Universal ................
Transmission Shaft and Center
Joints ......................................................2-457
Bearing .................................................... 2-465
Rear Axle Companion Flange .................2-472
Slip Yoke and Oil Seal ............................ 2-462
Transmission Companion Flange ...........2-469
PROPELLER SHAFTS AND UNIVERSAL JOINTS
This task covers:
a. Removal (page 2-458)
b. Installation (page 2-460)
INITIAL SETUP:
Tools
Materials/Parts
Block, wood (two required)
Grease, GAA (item 17, appendix C)
Caps, jaw, vise
Locking plates, universal joint
Hammer, ball-peen, 1 1/2-lb
(four required)
Handle, ratchet, 3/8-inch drive
Jack, hand, hydraulic, 12-ton
Personnel Required
Pliers, slip-joint, angle-nose
Punch, drive-pin, 1/4-inch
One
Socket, 318-inch drive, 9116-inch
Vise, machinist's
Equipment Condition
Vehicle parked with propeller shaft yokes
facing up and down for propeller shaft
removal (TM 9-2320-269-10).
Vehicle parked with propeller shaft yokes
facing side-to-side for universal joint
removal (TM 9-2320-269-10).
2-457
Previous Page
