TM 9-2320-269-20-1
PROPELLER SHAFTS AND UNIVERSAL JOINTS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
6.
Propeller
Propeller shaft yoke
Tip universal cross (10), slide shaft
shaft (7)
(1) and mating
yoke (1) out of mating yoke (2), and set
shaft (2)
propeller shaft (7) down.
7.
Propeller
Propeller shaft
Place shaft (7) in vise with caps, with
shaft (7)
yoke (1)
yoke (1) facing up and down.
8.
Propeller shaft
Two locking
Using hammer and punch, bend locking
yoke (1)
plates (3)
plate tabs (4) down.
9.
Four screws (5)
Using 9/16-inch socket and handle,
unscrew and take off.
10.
Two locking
Take off.
plates (3)
11.
Bearing caps
a. Place wood block against universal
(6) and (8)
cross bottom edge (10), and tap
sharply upward with hammer to force
bearing cap (6) out of yoke (1).
b. Rotate shaft 180 degrees in vise.
c. Using hammer, tap sharply downward to
force cap (8) out of yoke (1).
Tap each side of cross evenly so
cap does not jam sideways.
d. Using pliers, twist off.
12.
Universal cross (10)
Tip forward, and take out.
3-459
Previous Page
