TM 9-2320-269-20-1
FRONT HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
ADJUSTMENT- CONTINUED
4a
NOTE
FOLLOW-ON MAINTENANCE: Adjust brakes (page 2-478).
TASK ENDS HERE
REAR HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS
This task covers:
a. Removal (page 2-629)
d.
Assembly (page 2-632)
b. Disassembly (page 2-631)
e.
Installation (page 2-633)
c. Cleaning (page 2-632)
f.
Adjustment (page 2-634)
INITIAL SETUP:
Tools
Materials/Parts
Brush, stencil
Grease, GAA (item 17, appendix C)
Chisel, cold, hand
Lockring, bearing adjusting nut
Chocks, wheel (two required)
Rags, wiping (item 24, appendix C)
Driftpin, brass
Seal, grease
Extension, 3/4-inch drive, 8-inch
Seal, grease, bearing adjusting nut
Hammer, ball-peen, 2-lb
Solvent, drycleaning (item 28, appendix C)
Handle, ratchet, 314-inch drive
Jack, dolly-type, hydraulic
Personnel Required
Jack, hand, hydraulic, 12-ton
Pliers, slip-joint, angle-nose
Two
Screwdriver, flat-tip, 3/8-inch
Socket, 3/4-inch drive, 15/16-inch
Equipment Condition
Socket, 3/4-inch drive, 3 1/4-inch
Tool, sensor adjusting
Axle shaft removed (page 2-474).
Trestle, motor vehicle (two required)
Rear wheels removed (page 2-614).
Wrench, box-end, 9116-inch
Wrench, open-end, 15/16-inch
Wrench, torque, 314-inch drive
0 to 600 ft-lb capacity
2-628
Previous Page
