REAR HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
This procedure is for the right side rear-rear axle hub and drum. The procedure for the other rear hubs and drums is the same.
1. Slack adjuster (1)
Ring (2) and
Using 9116-inch box-end wrench, push
ring (2) in and turn screw (3) until hub (4)
It may be necessary to tap ring
with ball-peen hammer and
driftpin to free up.
2. Axle (5)
Lockring (6) and
Using ball-peen hammer and hand
cold chisel, straighten lockring (6).
Using 3 1/4-inch socket and handle
with 3/4-inch drive, unscrew and take
off nut (7).
Using 3/8-inch flat-tip screwdriver,
take off and get rid of lockring (6).
3. Locknut (7)
Take out, and get rid of.
4. Axle (5)
Using 3 1/4-inch socket and handle with
3/4-inch drive, unscrew and take off.