TM 9-2320-269-20-1
REAR HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
20. Exciter ring (7),
Three of five
Put through remaining holes.
drum (2), grease
screws (8)
guard (9), and
hub (1)
21.
Five nuts (10)
Screw on, and tighten to 145 to 175 ft-lb
(196.62 to 237.3 N m) of torque, using
15/16-inch socket, 8-inch extension,
torque wrench with 314-inch drive, and
15/16-inch open-end wrench.
22. Hub (1)
Two bearing
Press in using brass driftpin and hammer.
races (5)
INSTALLATION
23. Drum (2)
Wheel bearing (3)
a.
Lubricate bearing (3)
and washer (11)
(LO 92320-269-12).
b.
Put In.
24.
New grease seal (12)
Press In using brass driftpin and ball-
peen hammer.
25. Plate (13)
Wheel sensor (14)
Pull outward all the way using sensor
adjusting tool.
TA228971
2-633
Previous Page
