TM 9-2320-269-20-1
REAR HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
34. Axle (1)
Locknut (2)
Using 3 1/4-inch socket and handle with
3/4-inch drive, loosen, screw in and
tighten.
35. Hub (3)
Wheel and tire (4)
Install (page 2-614).
36. Axle (1)
Locknut (2)
a.
Screw in, and tighten to 50 ft-lb
(69 N m) of torque using 3 1/4-inch
socket and torque wrench with 3/4-
inch drive while turning tire (4).
b.
Using 3 1/4-inch socket and handle
with 314-inch drive, unscrew nut (2)
one-quarter turn.
37.
New lockring (5)
a.
Aline groove in lockring (5) to
b.
Aline tabs on lockring (5) to tabs
on locknut (2).
38. Locknut (6)
New seal (7)
Put into.
39. Axle (1)
Locknut (6)
Screw on until snug.
40.
Locknuts (2) and (6)
a.
Using ball-peen hammer and hand
cold chisel, bend lockring (5) down
onto locknut (2).
b.
Screw in, and tighten locknut (6) to
150 ft-lb (203 N m) of torque using
3 1/4-inch socket and torque wrench
with 3/4-inch drive.
41. Locknut (6)
Lockring (5)
Using slip-joint angle-nose pliers, bend
lockring (5) down onto locknut (6).
42. Computer module (8)
Three screws (9)
Using 3/8-inch flat-tip screwdriver,
and cover (10)
unscrew and and lift off cover (10).
43.
Sensor ter-
Connect voltmeter as shown to terminals
minals (11)
(11) for sensor being checked.
44. Axle (1)
Wheel and tire (4)
a.
Set voltmeter to AC.
b.
Spin tire (4) one revolution every two
seconds, and check meter reading for
more than .3 volts.
2-636
Previous Page
