REAR HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
ADJUSTMENT - CONTINUED
30. Vehicle (5)
Rear axle (1) and
Using hydraulic jack under axle (1),
lift until tire (8) is off ground.
Put trestles under axle (1) and frame
(7), and lower onto trestles.
Be sure tire is still off ground.
31. Slack adjuster (9)
Ring (10) and
Using 9/16-inch box-end wrench, push
ring (10) in and turn screw (11) until
tire (8) turns freely.
It may be necessary to tap ring
with ball-peen hammer and brass
driftpin to free up.
32. Axle (1)
Lockring (12) and
Using ball-peen hammer and hand
cold chisel, bend lockring (12)
Using 3 1/4-inch socket and handle
with 3/4-inch drive, unscrew and take
off nut (13), and get rid of lock-
33. Locknut (13)
Take out, and get rid of.