REAR WHEELS

TM 9-2320-269-20-1

REAR WHEELS

This task covers:

a. Removal (page 2-614)

c.

Installation (page 2-616)

b. Disassembly/Assembly (page 2-615)

INITIAL SETUP:

Tools

Tools - Continued

Chocks, wheel (two required)

Socket, 112-inch drive, 1 1/4-inch

Extension, 1/2-inch drive, 16-inch

Trestle, motor vehicle (two required)

Hammer, hand, ball-peen, 3-lb

Handle, hinged, 1/2-inch drive

Personnel Required

Handle, ratchet, 1/2-inch drive

Jack, hand, hydraulic, 12-ton

Two

ACTION

LOCATION

ITEM

REMARKS

REMOVAL

WARNING

When jacking vehicle, always block tires and support with two trestles to prevent personnel injury.

NOTE

This procedure is for the left side rear-rear axle wheels. The procedure for the left side forward-rear axle and right side rear-rear

and forward-rear axle wheels is the same.

1.

Five studs (1)

Five nuts (2) Using 1 1/4-inch socket, 16-inch exten-

sion and hinged handle with 1/2-inch

drive, unscrew until loose.

2.

Vehicle (3)

Right side front

Put wheel chocks firmly in front and

tire (4)

back of tire (4).

3.

Rear-rear axle (5),

a.

Using jack under axle (5), lift until

tires (6) and (7)

tires (6) and (7) are off ground.

and frame (8)

b.

Place trestles under axle (5) and

frame (8), and lower onto trestles.

Be sure tires are still off ground.

4.

Five studs (1)

Five nuts (2) Using 1 114-inch socket, 16-inch exten-

sion, and ratchet handle with 1/2-inch

drive, unscrew and take off.

2-614