FRONT HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED

TM 9-2320-269-20-1

FRONT HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

REMOVAL

NOTE

This procedure is for the right side hub and drum and wheel bearings. The procedure for the left side is the same.

1. Slack adjuster (1)

Ring (2) and

Using 9116-inch box-end wrench, push

screw (3)

ring (2) in, and turn screw (3) until hub (4)

turns freely.

It may be necessary to tap ring

with ball-peen hammer and driftpin

to free up.

2. Grease cap (5)

Six screws (6) and

Using 1/2-inch socket and handle

with1/2-inch drive, unscrew and take off.

Get rid of lockwashers (7).

3. Hub (4)

Grease cap (5)

Take off using ball-peen hammer.

and gasket (8)

Get rid of gasket (8).

4. Spindle (9)

Lockring (10) and

Using ball-peen hammer and hand

locknut (11)

cold chisel, bend lockring (10)

straight.

Using 2 7/8-inch socket and handle

with 314-inch drive, unscrew and take

off locknut (11).

Using angle-nose slip-joint pliers, take

off lockring (10), and get rid of.

TA228963

2-619

Index