TM 9-2320-269-20-1
FRONT HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS
This task covers:
a. Removal (page 2-619)
d.
Assembly (page 2-622)
b. Disassembly/Assembly
e.
Installation (page 2-622)
c. Cleaning (page 2-621)
f.
Adjustment (page 2-623)
INITIAL SETUP:
Tools
Materials/Parts
Brush, stencil
Gasket, grease cap
Chisel, cold, hand, 3/8-inch
Grease (item 17, appendix C)
Chocks, wheel (two required)
Lockring, bearing, adjusting nut
Driftpin, brass
Lockwasher, split, grease cap (six required)
Extension, 12-inch drive, 8-inch
Rags, wiping (item 24, appendix C)
Hammer, ball-peen, 1112-lb
Seal, grease
Handle, ratchet, 1/2-inch drive
Solvent, drycleaning (item 28, appendix C)
Handle, ratchet, 314-inch drive
Jack, hydraulic, hand, 12-ton
Personnel Required
Knife, putty
Pliers, slip-joint, angle-nose
Two
Screwdriver, flat-tip, 3/16-inch
Screwdriver, flat-tip, 318-inch
Equipment Condition
Sensor, adjusting tool
Socket, 1/2-inch drive, 112-inch
Front wheel and tire removed (page 2-611).
Socket, 1/2-inch drive, 15/16-inch
Socket, 3/4-inch drive, 2 7/8-inch
Trestle, motor vehicle (two required)
Wrench, box-end, 9/16-inch
Wrench, open-end, 15/16-inch
Wrench, torque, 3/4-inch drive,
0 to 600 ft-lb capacity
2-618
Previous Page
