REAR HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
INSTALLATION - CONTINUED
Do not rock hub and drum assembly when putting onto spindle to avoid pushing wheel sensor out of adjustment.
26. Axle (1)
Hub and drum (2)
With assistant, using dolly jack, put
Wheel bearing (3)
Lubricate (LO 9-2320-269-12).
Rotate hub and drum (2).
Screw on until snug.
If the hub and drum is being installed, go to step 35.
This procedure is for the right side rear-rear axle hub and drum. The procedure for the other rear hubs and drums is the same.
29. Vehicle (5)
Left front tire (6)
Put chocks in front of and behind tire (6).
When jacking vehicle, always block tires and support with trestles to prevent personnel Injury.