Section XIV. REAR AXLES

TM 9-2320-269-20-1

Section XIV. REAR AXLES

Page

Axle Shafts ................................................................

Breather Valve ...............................................

AXLE SHAFTS

This task covers:

b. Installation (page 2-475)

INITIAL SETUP

Tools

Materials/Parts

Extension, 1/2-inch drive, 10-inch

Gasket, axle flange

Hammer, hand, ball-peen, 1 1/2-lb

Rags, wiping (item 24, appendix C)

Handle, hinged, 1/2-inch drive

Oil, GO 80-90 (LO 9-2320-269-12)

Knife, putty

Sealer, silicone rubber (item 26,

Socket, 1/2-inch drive, 7/8-inch

appendix C)

Wrench, torque, 1/2-inch drive,

0 to 175 ft-lb capacity

Personnel Required

One

ACTION

LOCATION

ITEM

REMARKS

REMOVAL

NOTE

This procedure is for the left-rear axle shaft. The other rear axles are removed in the same way.

1.

Eight wheel hub

Eight nuts (2)

a. Using 7/8-inch socket, extension,

studs (1)

and hinged handle with 1/2-inch drive,

unscrew part way.

b. After all are loosened, take off.

CAUTION

Do not use screwdriver or pry bar to remove axle shaft. This can cause damage to the axle flange or wheel hub.

2-474