TM 9-2320-269-20-1
AIR COMPRESSOR GOVERNOR
This task covers:
a. Removal (page 2-602)
b. Installation (page 2-604)
INITIAL SETUP:
Tools
Personnel Required
Wrench, open-end, 7/16-inch
Two
Wrench, open-end, 1/2-inch
(two required)
Equipment Condition
Wrench, open-end, 9/16-inch
Wrench, open-end, 314-inch
Battery ground cable disconnected
Materials/Parts
Engine left side hood panel raised
Lockwashers, governor (two required)
Air reservoirs drained (page 2-106).
Tags, marking (item 29, appendix C)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
If governor is being removed to gain access to other components, go to step 2.
Tag hoses before removal to aid in installation (page 2-142).
1.
Three couplings (1)
Three hoses (2)
With assistant using 1/2-inch and 3/4-
inch wrenches, unscrew and take off.
2.
Elbow (3)
Linenut (4)
Using 7/16-inch and 9/16-inch wrenches,
unscrew.
3.
Two screws (5)
Two nuts (6) and
a. Using two 1/2-inch wrenches, unscrew
lockwashers (7) and take off.
b. Get rid of lockwashers (7).
4.
Governor (8)
Two screws (5), and
a. Hold governor (8) in place.
washers (9)
b. Take screws (5) and flat washers
(9) out of governor (8).
2-602
Previous Page
