TM 9-2320-269-20-1
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
17.
Air compressor (1)
Fitting (2)
Using 13/16-inch wrench, unscrew and
take off.
INSTALLATION
NOTE
If air compressor was removed for access to other components, go to step 26.
Install elbows and fittings in original positions to insure proper hookup of lines.
18.
Air compressor (1)
Fitting (2)
a. Wipe clean, and wrap with teflon
b. Screw in, and tighten using 13/16-
inch wrench.
19.
Bracket (3)
Place in position alining two screw holes.
20.
Bracket (3)
Two screws (4)
Screw in, and tighten using 1/2-inch wrench.
21.
Elbow (5)
a. Wipe clean, and wrap with teflon tape
b. Screw in, and tighten using 5/8-
inch wrench.
22.
Elbow (6), line (7),
a. Wipe clean, and wrap with teflon tape
b. Screw in, and tighten elbow (6)
using 9/16-inch wrench.
c. Put line (7) on, screw on,
and tighten nut (8) using two 9/16-
inch wrenches.
23.
Air compressor (1)
Two flanges (9), new
a. Clean any gasket material from
gaskets (10), four
flanges (9) with putty knife.
screws (11), and new
b. Match gaskets (10) to flanges (9),
c. Screw in, and tighten using 1/2- inch wrench.
2-598