TM 9-2320-269-20-2
DATA PLATES ATTACHED WITH DRIVE SCREWS
This task covers:
Replacement (page 2-1332)
INITIAL SETUP
Tools
Materials/Parts
Bit, drill, 1/8-inch
Data plate (as required)
Chisel, cold, hand, 1/2-inch
Drive screws (as required)
Drill, portable electric
Tape, pressure sensitive (item 31,
Hammer, ball-peen, machinist's
appendix C)
Punch, center, solid
Personnel Required
One
ACTION
LOCATION
ITEM
REMARKS
NOTE
The steps in this task are the same for all data plates secured with drive screws.
The rear winch
ENGAGE/DISENGAGE data plate is used as the example.
REPLACEMENT
WARNING
Eye protection must be worn while chiseling off heads of drive screws to avoid personnel injury.
NOTE
It will not be possible to drive or drill out shanks of old drive screws.
1.
Data plate (1)
Two drive
a. Using hammer and chisel, chisel
to body (2)
screws (3)
off heads.
2.
Body (2)
Data plate (1)
a. Take off.
b. Get rid of.
2-1332
Previous Page
