TM 9-2320-269-20-2
DATA PLATES ATTACHED WITH SELF-TAPPING SCREWS
This task covers:
Replacement (page 2-1334)
INITIAL SETUP
Tools
Materials/Parts
Hammer, hand, ball-peen,
Data plate (as required)
machinist's
Screw, self-tapping (as required)
Screwdriver, cross-tip, number one
Screwdriver, flat-tip, 1/4-inch
Personnel Required
Stamps, numbering
One
ACTION
LOCATION
ITEM
REMARKS
REPLACEMENT
NOTE
Except as noted, the steps in this task are the same for all data plates attached with self-tapping screws.
The manufacturer's identification plate is used as the example.
The manufacturer's identification plate uses cross-tip screws while all others use slotted screws.
1.
Data plate (1)
Four screws (3)
Using cross-tip screwdriver, unscrew
to door (2)
and data plate (1)
and take out.
NOTE
If data plate has stamped-in numbers, go to step 3.
2-1334
Previous Page
