TM 9-2320-269-20-2
CAB INSIDE DOOR AND WINDOW HANDLES
This task covers:
a. Removal (page 2-744)
b. Installation
INITIAL SETUP:
Tools
Personnel Required
Hammer, ball-peen, machinist's One
Pliers, long round-nose
Punch, drive-pin, straight,
5/32-inch
Screwdriver, flat-tip, 3/8-inch
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
The steps in this task are the same for all cab inside door and window handles. The left
window handle is used as the example.
1. Handle (1) to
Pin (3)
a. Using flat-tip screwdriver, pry back
shaft (2)
escutcheon (4).
b. Using punch and hammer, push out
pin (3).
2. Shaft (2)
Handle (1)
Take off.
3. Escutcheon (4)
Take off.
INSTALLATION
4. Shaft (2)
Escutcheon (4)
Put on.
5.
Handle (1)
Put on.
2-744
Previous Page
