TM 9-2320-269-20-1
PINTLE HOOK - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT
NOTE
If pintle only is being installed, go to step 10.
32. Nut (7)
Cotter pin (8)
a.
Using diagonal cutting pliers, bend
straight.
b.
Take out, and get rid of.
33. Pintle hook (5)
Nut (7)
Using 2 1116-inch open-end wrench,
loosen while assistant holds pry bar
through pintle (5).
34.
Pintle hook (5)
Lubricate (LO 9-2320-269-12).
35.
Nut (7) and new
a.
Tighten until pintle (5) binds when
cotter pin (8)
turning; then loosen, until
pintle (5) turns freely.
b.
Put in, and bend cotter pin (8) over
nut (7) using diagonal cutting pliers.
TASK ENDS HERE
Section XIX. SPRINGS
Page
Torque rods ..........................................................
TA229014
2-699
Previous Page
