TM 9-2320-269-20-1
TORQUE RODS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
3. Two clamps (4)
Two screws (6) and
a.
Using 7/16-inch socket and handle
and torque rod (5)
lockwashers (7)
with 3/8-inch drive, unscrew and
take out.
b.
Get rid of lockwashers (7).
4.
Torque rod (5)
Two clamps (4) and
Move aside.
hoses (8)
5.
Two nuts (9) and
Two cotter pins (11)
a.
Using diagonal cutting pliers, bend
shaft (10)
straight.
b.
Take out, and get rid of.
6.
Shaft (10)
Two nuts (9)
Using 1 11/16-inch socket, handle with
1/2-inch drive and 1 11/16-inch wrench,
unscrew and take off.
7.
Axle bracket (12)
Shaft (10)
Using ball-peen hammer and brass drift-
and torque rod (5)
pin, drive out.
8.
Two screws (13)
Two nuts (14)
Using 1 1/8-inch socket, handle with
1/2-inch drive, and 1 118-lnch wrench,
unscrew and take off.
9.
Crossmember (15)
Two screws (13) and
Take out while holding bracket (16) In
and bracket (16)
flat washers (17)
In place.
10. Axle bracket (12)
Torque rod (5) and
Lift torque rod (5) from axle bracket
and cross-
bracket (16)
(16), and take out.
member (15)
TA229015
2-701
Previous Page
