TM 9-2320-269-20-1
TRANSMISSION OIL PRESSURE SENDING UNIT
This task covers:
a. Removal (pages 2-308)
c.
Installation (page 2-309)
b. Installation (pages 2-308)
INITIAL SETUP:
Tools
Materials/Parts
Pan, drain
Rags, wiping (item 24, appendix C)
Pliers, slip-joint, angle-nose
Solvent, drycleaning (item 28, appendix C)
Screwdriver, flat-tip, 3/16-inch
Tags, marking (item 29, appendix C)
Wrench, open-end, 7/16-inch
Tape, teflon (item 32, appendix C)
Personnel Required
One
Equipment Condition
Battery ground cable disconnected
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Two sending unit
Two screws (2)
Using flat-tip screwdriver, unscrew
terminals (1)
and take out.
2.
Two lead wires (3)
a. Take off.
b. Tag wires (3).
3.
Transmission case
Oil pressure
a. Place drain pan underneath to
fitting (4)
sending unit (5)
catch draining fluid.
b. Using slip-joint pliers and 7/16-
inch wrench, unscrew and take off.
CLEANING
WARNING
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow open flame nearby when using solvent.
Failure to observe these precautions could cause serious injury or death.
2-308
Previous Page
