TM 9-2320-269-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE - CONTINUED
DOES NOT CRANK - CONTINUED
Step 11.
Test starting motor (1) with no load.
a. Connect 12-volt battery to ammeter capable of reading 300 amperes, and ground to starting
motor (1).
b
c.
Using jumper wire, connect starting motor solenoid BATT terminal (2) to starting motor (1) as
shown.
d. Check ammeter reading.
e. Disconnect battery and ammeter.
f.
If ammeter reads more than 150 amperes, replace starting motor (1) (page 2-288).
g. If ammeter reads less than 150 amperes, install starting (1) (page 2-288). Perform starting
procedures (TM 9-2320-269-10) again.
h. If engine does not start when following starting procedures (TM 9-2320-269-10), notify Direct
Support Maintenance.
TA228588
2-62