TM 9-2320-269-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE - CONTINUED
DOES NOT CRANK - CONTINUED
Step 4.
Inspect neutral lockout switch (1) and wires (2) for corrosion and damage.
a. Remove engine cover (3) (page 2-840) and transmission cover (4) (page 2-842).
b. Disconnect wires (2) and (5).
c.
If wires (2) are corroded or damaged, clean or repair as needed (page 2-142).
d. If wires (2) are corroded or damaged, clean or replace switch (1) using two 9/16-inch and 7/8-
Step 5.
a. Connect ohmeter to wires (2), check reading with transmission in neutral, and disconnect.
b. If meter reads more than zero ohms resistance, replace switch (1) (page 2-400).
c.
Connect wires (2) and (5), and install transmission cover (4) (page 2-842) and engine cover (3)
(page 2-840).
2-58