TM 9-2320-269-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE - CONTINUED
DOES NOT CRANK - CONTINUED
Step 9.
Test starting motor ground strap (2) and solenoid ground wire (3) for resistance.
a. Remove solenoid ground wire (3) and starting motor ground strap (2) using two 9/16-inch
wrenches, 314-inch deep well socket, handle, and flat-tip screwdriver as needed.
time, check reading, and disconnect.
c.
If meter reads more than zero ohms resistance, replace as needed.
d. Install solenoid ground wire (3) and starting motor ground strap (2) using two 9/16-inch
wrenches, 3/4-inch deep well socket, handle, and flat-tip screwdriver.
Step 10.
Inspect starting motor pinion (9) for damage.
a. If pinion (9) will not turn on shaft (10), replace starting motor (1) (page 2-288).
b. If pinion (9) will not turn armature (11) when turned with screw-driver, replace starting motor
(1) (page 2-288).
TA228587
2-61
Previous Page
