TM 9-2320-269-20-1
STARTING MOTOR
This task covers:
a. Removal (page 2-289)
b. Installation (page 2-294)
INITIAL SETUP
Tools
Materials/Parts
Brush, wire
Gasket, exhaust
Extension, 3/8-inch drive, 16-inch
Lockwasher, exhaust pipe heat shield to
Handle, ratchet, 3/8-inch drive
cylinder block
Screwdriver, flat-tip, 3/8-inch
Lockwasher, starting motor, flywheel
Socket, deep well, 3/8-inch drive,
housing (two required)
9/16-inch
Oil, penetrating (item 23, appendix C)
Socket, deep well, 3/8-inch drive,
Tags, marking (item 29, appendix C)
3/4-inch
Socket, deep well, 3/8-inch drive,
Personnel Required
1/2-inch
Socket, 3/8-inch drive, 9/16-inch
Two
Socket, 3/8-inch drive, 3/4-inch
Wrench, open-end, 1/2-inch (two
Equipment Condition
required)
Wrench, open-end, 11/16-inch
Battery ground cable disconnected
Wrench, open-end, 3/4-inch
Fuel filter (at heat shield) removed
2-288
Previous Page
