TM 9-2320-269-20-1
ORGANIZATIONAL TROUBLESHOOTING - CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE - CONTINUED
RUNS UNEVENLY - SURGES, STALLS, OR NO POWER - CONTINUED
Step 4. Test fuel system for pressure - Continued
c. Remove gage, and install plug using 9/16-inch and 5/8-inch wrenches.
d. If gage reads 3 to 5 psi (21 to 35 kPa), go to step 8.
Step 5. Inspect in-tank fuel pump (8) for corroded, loose, or damaged parts.
a. If pump terminal (9) or wire terminal (10) is corroded, remove wire (11) (page 2-
142) as needed, and install using 318-inch wrench.
b. If pump terminal (9) is damaged, replace pump (8) (page 2-167).
c. If wire terminal is loose, tighten using 3/8-inch wrench.
TA228593
2-67
Previous Page
