TM 11-5805-715-34/EE119-DB-MMI-010-E154 CV3478/TO 31W2-2TTC39-12
NOTE
NOTE
For the reasons explained above in
Disregard the fact that the signal names
(signal
name
differ from the names on the logic dia-
differences) the signal name on the
gram.
logic diagram should not be used to
locate the signal name in the signal
(4) Proceed to the signal string list (table
string list tables. Refer to tables 3-5
and 3-6 and follow the example steps
column. Reading from right to left, the destination
below.
other than to pin 0025 is to XA0011-0063.
(5) Proceed to the signal location table (table
(1) The signal to be traced is from logic card
NIU-A located on connector plate assembly nest,
signal goes to pin 63 of logic card NIU-B2.
and slot number 9 (see table 3-1); therefore,
connector XA 0009.
3-16. Redundant Cable Run Lists
(2)
Proceed to the logic diagram to
determine that the signal to be traced is from J1 pin
This paragraph provides information on how to use
25.
(3) Proceed to the signal location table (table
cable runs. A redundant format is used to facilitate
wire tracing by also entering the "TO" information
column). The signal name is PWRCL03 in the XA
of the "LOCATION" or "MARKING" columns in the
0009 NIU-A column for pin 0025.
"FROM" column in alphanumeric sequence. Figure
the following subparagraphs. Card field (CF) and
ballooned numbered items are used for reference
only.
3-13
Previous Page
