TM 11-5805-715-34/EE119-DB-MMI-010/E154 CV3478/TO 31W2-2TTC39-12
Table 3-7. NATO Interface Unit, Redundant Cable Wire Run List
NOTES
1.
Workmanship per MIL-STD-454, Requirement 9.
2.
Partial reference designations are shown. For complete designations prefix with unit number or assembly
or subassembly designations as applicable.
3.
Termination marking required. Hot-stamp per MIL-M-81531, black characters, centrally located. Marking
to be the same as indicated in the applicable location column unless otherwise specified.
4.
Entries in Group column denote specific lengths, see figures 3-2 and 3-3.
5.
Solder per MIL-STD-454, Requirement 5.
6.
A plus symbol before a pin letter (example: J2 +A) indicates a lower case letter.
7.
Heat shrink into position as shown.
8.
Quantity in inches, cut to 3/4 inch lengths.
9.
For connector and jackscrew information see table 3-8.
10.
For P1 keying, install item 6 (keying, pin) into location numbers 27 and 62.
11.
For P2 keying, install item 6 (keying, pin) into location numbers 33 and 68.
12.
Quantity in feet.
13.
Quantity in inches.
14.
For P3 keying, install item 6 (keying, pin) into location number 30.
15.
The numeral "15" in the applicable Note column denotes that two (2) wire ends are common to one piece
of termination hardware.
3-33
Previous Page
