TM 9-2320-269-20-1
TIE ROD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
8.
Tie rod end (1)
New dust cover (2)
Put on.
9.
Clamp (3)
Slide on.
NOTE
When installing tie rod end, use same number of complete turns needed on removal to
Insure proper wheel alinement.
10.
Tie rod (4)
Tie rod end (1)
Using two pipe wrenches, put in.
11.
Clamp (3)
Screw (5)
Slide in.
12.
Screw (5)
Nut (6)
Screw in, and tighten to 45 ft-lb (61 N m)
of torque using 15116-inch socket, torque
wrench, and 15/116-inch wrench.
13.
Steering arm (7)
Tie rod end (1)
Put in.
14.
Stud (8)
Nut (9)
Put on, and tighten to 220 ft-lb (298 N m)
of torque, using 1 5116 inch socket and
torque wrench.
Tighten further if needed, to aline
nut slot with stud hole.
15.
Nut (9)
New cotter pin (10)
Using diagonal cutting pliers, put in,
separate ends, and be nd back over nut (9).
2-656
Previous Page
