INSTRUMENT PANEL WARNING LIGHTS
This task covers:
a. Removal (page 2-332)
b. Installation (page 2-333)
INITIAL SETUP:
Tools
Personnel Required
Crimping tool
One
Pliers, diagonal cutting
Pliers, long round-nose
Stripper, wire
Equipment Condition
Materials/Parts
Battery ground cable disconnected
Lockwasher, retaining nut
Instrument panel removed (page 2-326).
Terminal, wire
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
CAUTION
Be careful working behind dash panel. You might damage hardware or electrical
wiring.
NOTE
To only change bulb, skip steps 3 thru 6.
1.
Instrument panel (1)
Light socket (2)
Reach behind panel (1), and pull
from
lens fitting (3).
2.
Light socket (2)
Bulb (4)
Take out, turning counterclockwise while
pressing inward.
3.
Instrument panel (1)
Lead wire (5/)
a.
Using diagonal cutting
pliers, cut lead
and light socket (2)
wire (5) two inches (50.80 mm) from
base of socket (2).
b.
Take out socket (2).
4.
Instrument panel (1)
Retaining nut (6)
a.
Using long round-nose
pliers,
and lockwasher (7)
unscrew and take off while holding
lens fitting (3) in place.
b.
Get rid of lockwasher (7).
2-332
Previous Page
