TM 11-5895-856-34-1/ E E640-CA-MMI-010/E 154 CPU/TO 31W2-2T-122-1
a. Removal. To remove a card cage connector
To remove a damaged connector contact, remove wires
contact, proceed as follows:
NOTE
0102/-1401, table 3-1) over wire wrap post; tap contact
The following procedure applies only
out as shown in figure 3-5, example A.
to removal and replacement of a
signal contact; ground and power
contacts employ a special sleeve and
require depot repair facilities for
removal
and
replacement.
3-14
Previous Page
