TM 9-2320-269-20-2
HEATER ASSEMBLY, HEAT CONTROL, AND VENT CONTROL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
NOTE
For disassembly of blower assembly, see page 2-1261.
36.
Heater assembly (1)
Grommets (2)
Using flat-tip screwdriver, pry out
and (3)
and slide up cable (4).
37.
HEAT cable (4)
Pushnut (6)
a. Using pliers, squeeze push nut.
to heater
b. Take off.
door arm (5)
c. Get rid of pushnut (6).
38.
HEAT cable (4) to
Screw (7)
Using 1 1/2-inch cross-tip screwdriver,
door arm (5)
clip (8)
unscrew and take out.
39.
Door arm (5)
HEAT cable (4)
Take off.
and spring (9)
40.
HEAT cable (4)
Grommet (3)
Take off.
41.
Heater assembly (1)
HEAT cable (4)
Take out.
42. HEAT cable (4)
Grommet (2)
Take off.
43.
WARNING
Drycleaning solvent burns easily. Do not smoke or have open flame
nearby while using solvent. Dispose of solvent soaked rags. If brush is
used, clean properly.
43.
Heater assembly (1)
Vent cable
a. With parts cleaning brush and rag, use
seal (10) and
solvent to dissolve glue.
air inlet seal (11)
b. Peel off.
44.
Backplate (12) to
Eleven screws (13)
Using 4-inch cross-tip screwdriver,
heater assembly (1)
unscrew and take out.
45.
Heater assembly (1)
Two clamps (14)
Using flat-tip screwdriver, raise up
and backplate (12)
high enough to get at clamps (14).
2-1276
Previous Page
