TM 9-2320-269-20-2
WINDSHIELD WIPER MOTOR
This task covers:
a. Removal (page 2-1228)
b. Installation (page 2-1232)
INITIAL SETUP:
Tools
Materials/Parts
Chisel, cold, hand, 3/8-inch
Detergent, liquid (item 11, appendix C)
Hammer, ball-peen, machinist's, 2-oz
Grease, GAA (item 17, appendix C)
Handle, ratchet, 3/8-inch drive
(as required)
Key, socket-head screw, 5/64-inch
Lockwasher, bracket-to-motor
Screwdriver, flat-tip, 3/16-inch
(three required)
Screwdriver, flat-tip, 3/8-inch
Lockwasher, pivot plate-to-wiper motor
Socket, 3/8-inch drive, 3/8-inch
Tags, marking (item 29, appendix C)
Socket, deep well, 3/8-inch drive,
7116-inch
Personnel Required
One
Equipment Condition
Battery ground cable disconnected
(page 2-414).
Left side of hood open (page 2-7).
Defroster duct removed (page 2-1247).
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Inside cab:
Setscrew (3)
Using key, unscrew and take out.
windshield wiper
knob (1) to
switch (2)
2.
Switch (2)
Knob (1)
Take off.
3.
Switch (2) to
Nut (5)
a. Using chisel and hammer, loosen.
dashboard (4)
b. Unscrew, and take off.
4.
Dashboard (4)
Switch (2)
Push through, and pull down.
2-1228
Previous Page
