TM 9-2320-269-20-2
WINDSHIELD WIPER MOTOR - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
17.
Bracket (1) to
Three screws (3)
a. Using 3/8-inch flat-tip screwdriver,
motor (2)
and lockwashers (4)
unscrew and take out.
b. Get rid of lockwashers (4).
18.
Motor (2)
Bracket (1) and
Take off.
rubber spacer (5)
19.
Bracket (1)
Rubber spacer (5)
Take out.
INSTALLATION
20.
Bracket (1)
Rubber spacer (5)
Put in place inside bracket (1).
21.
Motor (2)
Bracket (1) and
Put onto motor (2).
rubber spacer (5)
22.
Bracket (1) to
Three screws (3)
Screw in, and tighten using 3/8-inch
motor (2)
and new
flat-tip screwdriver.
washers (4)
23.
Bracket (1)
Seal (6)
Put small amount of grease on seal to
hold in place, and put onto bracket (1).
24.
Firewall (7)
Motor (2) and
Put in place, and hold.
bracket (1)
25.
Motor (2) and brac-
Two screws (8)
Screw in, and tighten using 3/8-inch
ket to firewall (7)
socket and handle.
26.
Firewall (7)
Three wires (9),
Feed through hole in firewall (7).
(10), and (11)
2-1232
Previous Page
