TM 9-2320-269-20-2
WINDSHIELD WIPER REFILL
This task covers:
a. Inspection(page 2-1216)
c.
Installation(page 2-1217)
b. Removal page 2-1216)) .
INITIAL SETUP:
Tools
Personnel Required
Screwdriver, flat-tip, 1/8-inch,
One
ACTION
LOCATION
ITEM
REMARKS
INSPECTION
NOTE
The steps in this task are the same for both left and right windshield wiper refills. The
left windshield wiper refill is used as the example.
1.
Windshield wiper
Refill (2)
a. Inspect for cracked, chipped, torn,
blade (1)
or worn rubber.
b. Pull out slightly from windshield (3),
and flick your thumb across the refill
(2) at right angles in two or three
places.
Rubber should spring back.
c. Squeeze to see if refill (2) is hard.
If cracked, chipped, torn, worn,
hardened, or if rubber fails to spring
back, replace refill.
REMOVAL
2.
Refill (2) to
End clip (4)
Using flat-tip screwdriver on either end,
blade (1)
pry up and pull off of refill (2).
3.
Blade (1)
Refill (2)
Slide out.
4.
Refill (2)
Other end clip (4)
Using flat-tip screwdriver, pry up and
pull off.
2-1216
Previous Page
