TM 9-2320-269-20-2
CAB DOOR AND HINGES
This task covers:
a. Removal (page 2-706)
c.
Installation (page 2-712)
b. Repair (page 2-709)
d.
Adjustment (page 2-713)
INITIAL SETUP:
Tools
Materials/Parts
Extension, 3/8-inch drive, 5-inch
Board, 2-in. x 4-in. x 8-ft
Hammer, ball-peen, machinist's, i-lb
(5 cm x 10 cm x 1.24 cm)
Handle, ratchet, 3/8-inch drive
Plywood, 3-in. x 3-in. x 5/16-in.
Punch, drive-pin, straight, 118-inch
(9.6 cm x 9.6 cm x 2 cm)
Screwdriver, cross-tip, number two
Screwdriver, cross-tip, number four
Personnel Required
Socket, 3/8-inch drive, 1/2-inch
Vise, machinist's
Three
Equipment Condition
Cab door inner panel removed (page 2-730).
Rear view mirror assembly removed
(page 2-1309).
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
To prevent personnel injury, two people are required during door removal and
installation.
NOTE
The steps in this task are the same for both right and left cab door. The left door is
used as the example.
If only adjusting door, go to step 28.
2-706
Previous Page
