TM 9-2320-269-20-1
WINCH, WINCH SUPPORT, AND BUMPER ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
10.
Winch, winch
Two screws (3) and
a. Using 15116-inch box-end wrench,
support, and
self-locking nuts (4)
15116-inch socket, and handle with
bumper assembly
112-inch drive, unscrew and take out.
(1) to right support
b. Get rid of nuts (4).
bracket (2)
11.
Winch, winch
Two screws (7),
a. Using 15/16-inch box-end wrench,
support, bumper
nuts (8), and
1 1/16-inch socket, and handle
assembly (1),
lockwashers (9)
with 1/2-inch drive, unscrew and
and two spacers
take off.
(5) to right front
Do not take out screws (7).
spring bracket (6)
b. Get rid of lockwashers (9).
12. Front spring
Winch, winch
a. Raise hoist enough to remove
brackets
support, and bumper
trestles.
(6) and (10) and
assembly (1)
b. Remove trestles.
spacers (5) and (11)
c. Using hoist, remove assembly (1).
INSTALLATION
13.
Front spring
Winch, winch sup-
a. Using hoist, put winch, winch support,
brackets
port, and bumper
and bumper assembly (1) into
(6) and (10) and
assembly (1)
place working it onto screws
spacers (5) and (11)
(7) and (12).
b. Raise assembly (1) slightly, and
put trestles into place under
main beams of assembly (1).
c. Using hoist, lower assembly into
place.
14.
Winch, winch sup-
Two screws (7),
a. Screw on lockwashers (9) and nuts (8).
port, bumper
nuts (8), and new
b. Tighten screws (7) using 15116-inch
assembly (1), and
lockwashers (9)
box-end wrench.
two spacers (5) to
c. Tighten nuts (8) using 1 1/16-inch
right frort spring
socket and handle with 1/2-inch drive.
bracket (6)
15.
Winch, winch sup-
Two screws (3) and
Screw in, but do not tighten using
port, and bumper
new self-locking
15/16-inch box-end wrench, 15/16-inch
assembly (1)
nuts (4)
socket, and handle with 1/2-inch drive.
to right support
bracket (2)
2-684
Previous Page
