TM 9-2320-269-20-1
TRANSMISSION CONTROL CABLE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT
NOTE
If swivel is being installed, go to step 27.
If cable or pivot are being installed, go to step 28.
24.
Swivel (1)
Cotter pin (2)
Using diagonal cutting pliers, take out
25.
Lever (3)
Washers (4) and (5)
Take out.
and swivel (1)
26.
Cable (6)
Locknut (7) and
a. Using 7/16-inch wrench and pliers
swivel (1)
wrench, loosen locknut (7).
b. Using 1/2-inch wrench and pliers
wrench, unscrew and take off swivel
(1) and locknut (7).
c.
Get rid of locknut (7).
27.
Gate (8)
Control handle (9)
Move to number 1 position.
28.
Cable (6)
New locknut (7)
Using 7/16-inch wrench and pliers
wrench, screw on all the way.
29.
Transmission (10)
Lever (3)
Move to the FORWARD position.
30.
Cable (6)
Swivel (1)
Using 7116-inch wrench and pliers wrench,
screw on until even with lever (3).
31.
Lever (3)
Swivel (1) and
Put on washer (4), and put swivel (1)
washer (4)
through.
32.
Swivel (1)
Two washers (5)
a. Put on washers (5).
and new cotter
b. Put cotter pin (2) through, and bend
pin (2)
over using diagonal cutting pliers.
33.
Cable (6)
Locknut (7)
Screw against swivel (1), and tighten
using 1/16-inch wrench and pliers wrench.
2-450
Previous Page
