TM 9-2320-269-20-1
RUNNING LIGHTS
This task covers:
c.
d.
INITIAL SETUP
Tools
Personnel Required
Caps, jaw vise
One
Screwdriver, cross-tip, number two
Screwdriver, flat-tip, 3/8-inch
Equipment Condition
Vise, machinist's
Headliner removed for removal of light
assembly (page 2-838).
Materials/Parts
Gasket, lens
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
There are five running lights on cab roof. This procedure can be used for any one of them.
If only bulb is being removed, go to step 6.
1.
Harness
Lead wire
Disconnect.
connector (1)
connector (2)
2.
Running light (3)
Adjusting screw (4)
Using flat-tip screwdriver, unscrew
part way.
3.
Two mounting
a.
Turn light (3) to get to screw (5).
screws (5)
b.
Using cross-tip screwdriver, unscrew
and take out.
4.
Mounting plate (6)
Take off.
5.
Cab roof (7)
Running light (3)
Take off.
2-378