TM 9-2320-269-20-1
MARKER LIGHTS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
1.
Marker light (1)
Lens (2)
Using flat-tip screwdriver, pry out.
2.
Lens gasket (3)
a.
Take off.
b.
Get rid of.
3.
Marker light bulb
Two bulbs (5)
Push in, turn counterclockwise and take
clips (4)
out.
CAUTION
4.
Lead wire
Lead wire (7)
Using soldering gun, heat solder until
contact (6)
wire (7) is free.
5.
Marker light (1)
Two screws (8)
Using flat-tip screwdriver, unscrew and
take out.
6.
Stowage box (9)
Marker light (1)
Take off.
7.
Gasket (10)
a.
Take off.
b.
Get rid of.
INSTALLATION
NOTE
Before installing new gaskets, be sure gasket mating surfaces are free of dirt or old
gasket material to insure proper seal.
8.
Stowage box (9)
New gasket (10) and
a.
Place lead wire (7) through gasket
marker light (1)
(10) and light (1).
b.
Put gasket (10) and light (1) against
stowage box (9), and hold in place.
9. Marker light (1)
Two screws (8)
Screw in, and tighten using flat-tip
screwdriver
10.
Lead wire
Lead wire (7)
Using soldering gun and solder,
contact (6)
solder in place.
2-382
Previous Page
