TM 9-2320-269-20-1
ALTERNATOR DRIVE BELTS
This task covers:
a. Removal (page 2-282)
b. Installation (page 2-282)
INITIAL SETUP
Tools
Equipment Condition
Handle, ratchet, 3/8-inch drive
Raise hood (page 2-7).
Socket, 3/8-inch drive, 1/2-inch
Battery ground cable disconnected
Socket, 3/8-inch drive, 9/16-inch
Wrench, open-end, 9/16-inch
Engine right side hood panel raised
Personnel Required
Water pump drive belts removed (page 2-244).
One
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1. Alternator (1) to
Nut (3) and
Using 9/16-inch socket, handle, and
mounting bracket (2)
screw (4)
wrench, unscrew part way.
2. Alternator (1) to
Screw (6)
Using 1/2-inch socket and handle,
adjusting bracket(5)
unscrew part way.
3. Alternator
Drive belts (8)
Take off.
pulley (7)
INSTALLATION
4. Alternator (1) to
Nut (3) and
Tighten using 9/16-inch socket, handle,
mounting bracket (2)
screw (4)
and wrench.
5. Alternator
Drive belts (8)
Put on.
pulley (7)
6. Alternator (1) to
Screw (6)
a. Pull alternator (1) tight until belts
adjusting bracket (5)
(8) have 1/2 inch (1.27 cm) deflection.
b. Tighten using 1/2-inch socket and
handle.
2-282
Previous Page
