TM 9-2320-269-20-2
UPPER AND LOWER HINGE PILLAR DUST SEAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
The steps in this task are the same for both right and left door opening dust seals.
1. Upper dust seal
Four clips (3)
Using flat-tip screwdriver, pry out.
(1) to hinge
pillar (2)
WARNING
Drycleaning solvent burns easily. Do not smoke or have open flame nearby when using
solvent. Dispose of solvent-soaked rags. If brush is used, clean properly.
2.
Upper dust seal
a. Using brush, apply drycleaning solvent
(1) and lower
sparingly to joint between seals (1)
dust seal (4) to
and (4) and pillar (2) to soften
hinge pillar (2)
adhesive.
b. Wipe off any excess solvent with rag
to prevent possible damage to paint.
3. Hinge
Upper dust seal
Using putty knife, peel off.
pillar (2)
(1) and lower
dust seal (4)
4. Hinge pillar (2)
Using rag and drycleaning solvent, clean
off any remaining adhesive.
INSTALLATION
5. Upper dust seal (1)
a. Using pocket knife, cut to same length
as old upper dust seal (1).
b. Hold in place on hinge pillar (2) and
using awl, punch holes in upper dust
seal (1) in line with holes in hinge
pillar (2).
2-760
Previous Page
