TM 9-2320-269-20-1
IDLER PULLEY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING - CONTINUED
WARNING
Solvent burns easily. Solvent fumes can explode. Do not smoke or allow open flame
nearby when using solvent. Failure to observe these precautions could cause serious
injury or death.
11.
All metal parts
Clean in drycleaning solvent.
INSPECTION/REPLACEMENT
NOTE
For more information on how to inspect parts, go to General Maintenance Instructions
Replace damaged or defective parts as needed.
12.
Idler pulley (1)
a. Look for scratches, cracks, and nicks
on belt contact surfaces.
b. Look for scratches and cracks on
bearing bore.
13.
Idler arm (2)
Look for bends, breaks, cracks, and
distortion.
ASSEMBLY
14. Idler pulley (1)
Retaining ring (3)
Using snapring pliers, put in.
NOTE
Do not do step 15 unless bearing was removed.
15.
Bearing (4)
Using bearing remover and flat washer,
press in until seated against ring (3).
2-276
Previous Page
