TM 9-2320-269-20-1
TEFLON TAPE - CONTINUED
CABLE TIES
New cable ties should be used to hold loose wires or hoses together and in place.
1.
Hold wires or hoses together tightly.
2.
Lay cable tie head against wires or hoses, and wrap loose end around.
3.
Push loose end through opening, and pull tight using slip-joint pliers if needed.
There are two basic cotter pin installations for slotted nuts and clevis pins. Steps 1 thru 3 are for slotted nuts,
and steps 4 thru 6 are for clevis pins.
1.
Put cotter pin through nut and screw.
2.
Roll long end of pin over end of screw using long-nose pliers, and tap pin onto screw using hammer.
3. Cut short end of pin with diagonal pliers if needed, and bend down into nut using long- nose pliers.
TA228650
2-148