TM 9-2320-269-20-1
FRONT HUB AND DRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
37. Spindle (1)
New lockrlng (2)
a.
Put on ring (2).
and locknut (3)
b.
Screw on nut (3) until snug.
38.
Locknuts (3) and (4)
a.
Using ball-peen hammer and hand
cold chisel, bend lockring (2) down
onto locknut (4).
b.
Using 2 7/8-inch soc ket and torque
wrench with 3/4-inch drive, tighten
locknut (3) to 150 ft-lb (203 N m)
39.
Lockring (2)
Using angle-nose slip-joint pliers, bend
lockring (2) down onto locknut (3).
40. Computer module (5)
Three screws (6)
Using 3/8-inch flat-tip screwdriver,
and cover (7)
unscrew and lift off cover (7).
41.
Sensor terminals (8)
(8) for sensor being checked.
42. Spindle (1)
Wheel and tire (9)
a.
Set voltmeter to AC.
b.
Spin tire (9) one revolution every
two seconds, and check meter
reading for more than .3 volts.
43. Computer module (5)
Sensor terminals (8)
44. Vehicle (10)
Left front wheel
Repeat steps 28 thru 30 for left
and tire (11)
wheel and tire (11).
45. Computer module (5)
Sensor ter-
a.
Repeat steps 39 thru 42 for left
minals (12)
sensor terminals (12).
b.
If meter reads less than .3 volts at
either set of terminals, repeat
adjustment for that side.
46.
Grease cap (14)
a.
Cover spindle (1) with clean rags.
b.
Using putty knife clean away any old
gasket material.
c.
Take off rags.
47. Hub (13)
Grease cap (14) and
Put on, and hold In place.
new gasket (15)
2-626