TM 9-2320-269-20-2
ELEVATION HYDRAULIC CYLINDER - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
22.
(Continued)
f.
Tighten nut (4) to 30-40 ft-lb
(41-54 N.rn) using 9/16-inch socket
g. Pull on turret winch line again
(TM 9-2320-269-10), and check
pressure gage reading.
If necessary, re-adjust setscrew and
retorque jamnut following steps a
thru f until reading is correct.
23.
Vehicle
Derrick leg (3)
a. Lower anchor, and unhook anchor
(TM 9-2320-269-10).
b. Stow winch line, retract leg (3),
and position in stowed position
(TM 9-2320-269-10).
c. Shut down engine (TM 9- 2320-269-10).
24.
Elevation
Plug (2)
a. Remove pressure gage.
cylinder (1)
b. Screw in, and tighten using 1/4-inch
key
NOTE
FOLLOW-ON MAINTENANCE: Test operation of elevation hydraulic cylinder (TM 9-
2320-269-10).
TASK ENDS HERE
TA229289
2-1091