TM 9-2320-269-20-1
TRANSMISSION SHIFTER ILLUMINATING LIGHT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
2.
Shifter support (1)
Indicator cover (2)
Take off.
3.
Light socket (3)
Bulb (4)
a.
While pushing in, turn
counterclockwise and take out.
b. Use tape to pull bulb (4) out of
socket (3).
4.
Lead wires (5)
Using diagonal cutting pliers, cut
and (6)
wire (5) above and below existing
connector (7).
5.
Shifter support (1)
Light socket (3)
a.
Using flat-tip screwdriver,
bend one
edge of socket (3) up.
b.
Using long round-nose pliers,
pull out.
INSTALLATION
NOTE
To only change bulb, skip steps 6 thru 8.
6.
Shifter support (1)
Light socket (3)
a.
Position new socket (3) in
support (1),
feeding lead wire (5) through back
of support (1).
b.
Press into place.
7.
Socket lead wire (5)
Connector (7)
a.
Using wire strippers, strip
1/2-inch
(12.7 mm) of insulation from wire (5),
and fold back onto casing (8).
b.
Place connector (7) over wire (5).
c.
Using crimping tool, crimp into place.
8.
Harness lead
Connector (7)
a.
Using wire strippers, strip
112-inch
wire (6)
(12.7 mm) of insulation from wire (6)
and fold back onto casing (9).
b.
Place connector (7) over wire (6).
c.
Using crimping tool, crimp into place.
2-342
Previous Page
